Publicidad
Idiomas disponibles
Idiomas disponibles
English
⚠ WARNING
• Make sure that you do not exceed your maximum heart rate
during your workout� If you belong to a risk group, consult a
physician�
Beginner
50-60% of maximum heart rate
Suitable for beginners, weight-watchers, convalescents and persons
who have not exercised for a long time� Exercise at least three times a
week, 30 minutes at a time�
Advanced
60-70% of maximum heart rate
Suitable for persons who want to improve and maintain fitness�
Exercise at least three times a week, 30 minutes at a time�
Expert
70-80% of maximum heart rate
Suitable for the fittest of persons who are used to long-endurance
workouts�
Use
Adjusting the support feet
The equipment is equipped with adjustable support feet�
If the equipment feels unstable, wobbly, or not levelled well, these
support feet can be adjusted to make the required corrections�
- Turn the support feet in/ out as required to put the equipment in a
stable and as well possible levelled position�
‼ NOTE
• The equipment is most stable when it is as low to the floor as
possible� Therefore, start to level the equipment by turning all
support feet fully in, before turning out the required support feet
to stabilize and level the equipment�
Adjusting the horizontal seat position
The horizontal seat position can be adjusted by setting the seat to
the required position�
- Loosen the seat adjustment knob�
- Move the seat to the required position�
- Tighten the seat adjustment knob�
Adjusting the vertical seat position
The vertical seat position can be adjusted by setting the seat tube
to the required position� With the leg almost straight, the arch of the
foot must touch the pedal at its lowermost point�
- Loosen the seat tube adjustment knob�
- Move the seat tube to the required position�
- Tighten the seat tube adjustment knob�
Power supply (Fig. E)
The trainer is powered by an external power supply� Refer to the
illustration to locate the trainer power input�
‼ NOTE
• Connect the power supply with the trainer before connecting it
to the wall outlet�
• Always remove power cord when machine is not in use�
Console (fig F)
1
2
3
1
Display
2
Tablet/ book support
3
Buttons
⚠ CAUTION
• Keep the console away from direct sunlight�
• Dry the surface of the console when it is covered with drops of
sweat�
• Do not lean on the console�
• Only touch the display with the tip of your finger� Make sure that
your nails or sharp objects do not touch the display�
‼ NOTE
• The console switches to standby mode when the equipment is
not used for 4 minutes�
Explanation Display functions
Time
- Without setting the target value, time will count up�
- When setting the target value, time will count down from your
target time to 0 and alarm will sound or flash�
- Without any signal being transmitted into the monitor for 4
seconds during workout, time will STOP
- Range 0:00~99:59
Speed
- Displays current training speed�
Maximum speed is 99�9 KM/H or ML/H�
- Without any signal being transmitted into the monitor for 4
seconds during workout, SPEED will display "0�0"
RPM
- Displays the Rotation Per Minute�
Display range 0~15~999
- Without any signal being transmitted into the monitor for 4
seconds during workout, RPM will display "0"
WATTS
- Display current workout watts�
- Range 0 ~ 999
Distance
- Without setting the target value, distance will count up�
- When setting the target value, distance will count down from your
target distance to 0 with an alarm sound or flash�
- Range 0�00~99�99
1 8
Publicidad
