Routine Maintenance; Moving The Machine - Nussbaum TC 410 Manual De Instrucciones

WARNING!
Before making any inspection, adjustment or repair be certain power source is disconnected:
1) disconnect the machine from the mains electric supply.
2) disconnect the machine from the compressed air circuit by detaching the compressed air line from the quick
couple.
Perform the following routine maintenance operations:
1) From time to time (about every 15 days) check the oil level in the lubricator, which
should be between the "MIN" and "MAX" indicators on the jar (1, Fig. N).
Top up as needed as follows:
- Unscrew the jar (1, fig. N)
- Top up with ISO VG 32 viscosity ISO HG class oil for compressed air circuit (such as
ESSO Febis K32; Mobil Vacouline Oil 1405; KLUBER Airpress 32).
2) Every 2 or 3 days check if after every 2 or 3 pedal movements (3 or 5, Fig. E) a drop
of oil falls into the lubricator glass cup.
If it does not, adjust the lubricator regulating screw using a screwdriver (see Fig. N).
3) Clean the machine daily to remove any dirt or tyre debris from the wheel clamp jaw
slides.
Lubricate these slides using ISO VG 68 viscosity ISO HG class grease (such as, for example
ESSO Febis K68; Mobil Vactra 2; Shell Tonna Oil 68).
4) To ensure correct operation of the inflation device pressure limiter (Refer to the section on "SAFETY DEVICES", of this manual), it is es-
sential to carry out the following routine
checks:
- Check the water level in the water trap to the air supply (2, Fig. N), which must NEVER exceed the "MAX DRAIN" level indicator on the
water trap itself.
When necessary, drain the water by turning the locking ring (3, Fig. N) clockwise.
- Every 30-40 days disconnect the machine from the compressed air circuit and dismantle the glass (2, Fig. N) to remove any solids collected
inside it.
To handle the machine, follow the instructions given below:
1) Close the table top clamps completely.
2) Rotate the table top to bring it to the position shown in Fig. O/1.
3) Disconnect all the power supplies to the machine.
4) Move the horizontal slide (11, Fig. E) to end of travel (fully forwards) and completely
lower the hexagonal arm (10, Fig. E).
5) Pass a belt between the 2 front recesses of the table top and behind the toolhead (see
Fig. O/1) to prevent the post from slipping out.
6) Pass a second belt around the horizontal slide (see Fig. O/2). Make sure that you insert
it under the plastic guide (1, Fig. O/2) to prevent the components from being crushed.
TC 410

12. ROUTINE MAINTENANCE

13. MOVING THE MACHINE

36
(1*/,6+ ‡ ,QVWUXFWLRQV PDQXDO
2
3
1
N
0/1