Publicidad
During welding, the current and voltage displays show the welding current and
voltage, respectively.
The information shown below is displayed in standby mode:
Welding type
MMA
TIG
MIG
During MIG welding:
• when the current control knob is not turned, the current welding current is
displayed,
• when the current adjustment knob is turned, the set wire feeding speed is
displayed.
Setting the system parameters
The default welding parameters of this machine can be modified as follows:
1. While the welding machine is off press and hold the 2T/4T mode switch [9], switch
the ON/OFF button [12] to the ON position to turn the welding machine on. As soon
as the display shows "P1", release the 2T/4T [9] button to enter the system setting
adjustment interface.
2. Select the MIG, TIG or MMA system parameters by pressing the welding mode
button [8].
3. Select the parameter to be checked by turning the welding voltage adjustment
knob [2]. Check the parameter value by turning the welding current adjustment knob
[3]. After correction, press the manual wire feed button [10] to save the settings.
4. When the parameter adjustment is complete, press the 2T/4T button [9] to exit the
system setting and enter the normal standby mode.
Wire feed speed adjustment
Welding current
Welding parameters display
Voltage display
Open circuit voltage or VRD
voltage (V)
Open circuit voltage or VRD
voltage (V)
Set voltage value (V)
Current display
Set current value (A)
Set current value (A)
Set wire feed value (m/min)
Publicidad
