Descargar Imprimir esta página

STAMOS POWER2 S-MAG 180 Manual De Instrucciones página 66

Publicidad

device.
- Connect the plug of the ground wire to the negative (-) output terminal of the
welding machine.
- Connect the plug of the welding cable contained in the cable harness to the
positive (+) output terminal of the welding machine. Connect the other end of
the welding cable to the wire feeder.
- Connect the control wire contained in the cable bundle to the center terminal
of the welding machine. Connect the other end of the control wire to the wire
feeder.
- Connect the gas hose to the shielding gas cylinder (the cylinder should be
equipped with a pressure regulator). Connect the other end of the gas hose to
the gas connection on the wire feeder.
- Connect the MIG/MAG welding handle to the Euro connector on the front
panel of the wire feeder.
- Connect the ground terminal to the workpiece.
- Turn on the power supply.

Publicidad

loading

Este manual también es adecuado para:

Power2 s-mag 200