Publicidad
C - Ground wire
D - Workpiece
E - MIG torch holder
S-MAG 350D
CAUTION!
- Connection to the electrical system should be made by a qualified electrician
- The electrical system should be equipped with a 60A fuse
MMA WELDING MODE (S-MAG 350D):
1) Connect the welding cable to the connection marked with "+" and
twist the cable plug to secure the connection.
2) Connect the ground wire to the connection marked with "-" and twist
the wire connector to secure the connection.
3)
CAUTION! Cable polarity may vary! All polarity information should
be described on the package provided by the electrode manufacturer!
4) Connect the unit to the power supply.
5) Connect the ground wire to the workpiece. Once these steps are
completed, welding can begin.
Publicidad
