Publicidad
A - Clamping force adjustment knob
B - Pressure roller arm
C - Output guide
D - Drive roller fixing knob
E - Drive roller
F - Input guide
4) Unscrew the drive roller fixing knob (D) and make sure that the drive
roller size (E) is suitable for the wire to be mounted (replace with
another drive roller if necessary). Re-tighten the drive roller fixing
knob (D).
5) Disconnect the end of the wire from the spool. Maintain wire tension
to prevent the spool from unwinding.
6) Cut off the bent part of the wire and straighten the initial 10 cm of the
wire.
7) Thread the wire through the feeder input guide (F), over the drive
roller (E), feed the wire through the center tube and slide it into the
feeder output guide (C).
Publicidad
