moisture, the Multifunctional steam mop should only be used
on properly sealed floor surfaces.
•
Due to large size of the Mop Head, it may have difficulty completely
cleaning certain types of floors (such as ceramic tile) that include
crevices of grouting. To more thoroughly clean floor grout, it is
recommended to use Multifunctional steam mop in steam cleaning
mode.
OPERATING THE Multifunctional steam mop
STEAM CLEANING
•
Make sure desired cleaning accessories (Concentration nozzle,
Small round brush) are properly connected.
•
For general cleaning convenience, Extension Pole should be
removed so that unit functions as a handheld steam cleaner.
However, Pole may be attached for cleaning hard-to-reach spots,
such as floor grout or ceilings. BE CAREFUL TO SUPPORT POLE
WITH TWO HANDS WHEN LIFTING.
•
Direct Concentration nozzle towards surface you with to steam.
Use a slight back-and-forth motion over area to enhance the
cleaning process. To sanitize surfaces, set Steam Control Dial to
HIGH and hold Jet Nozzle approximately 1/2 inch from surface
for at least 5 seconds. This will most effectively kill germs and
bacteria.
•
Wipe steamed areas with a clean cloth to remove loosened dirt and
grime. Wiping the area while it is still wet is recommended, but use
caution when wiping surfaces such as metal that may still be hot.