Publicidad
Idiomas disponibles
Idiomas disponibles
3. Use Measuring Cup to make a mixture of approximately 100ml.
distilled water and 50ml. vinegar.
4. Slowly pour water-vinegar solution into Water Tank through fill hole,
then replace Water Tank Cap.
5. Plug in power cord, set Steam Control Dial to HIGH, and spray full
contents of Water Tank into a sink or tub.
6. Once Water Tank is drained, turn unit off and refill Tank with
380mL. of fresh distilled water. Set Steam Control Dial back to
HIGH and repeat STEP 5. If you used a water-vinegar solution, you
may need to repeat this until vinegar odor dissipates.
7. Replace Water Tank Cap, unplug power cord, and store
Multifunctional steam mop as usual.
IMPORTANT: On average, it is recommended that you follow the
Removing Mineral Build-up procedure once per month (if unit is
used once every week). More frequent use may require following
the procedure more often in order to keep your Multifunctional
steam mop operating at full potential. Do not exceed 20 hours of
use without cleaning out mineral build-up.
Publicidad
