Publicidad
Idiomas disponibles
Idiomas disponibles
Filling water tank
NOTE: Do not remove or cut small rubber air valve on top of
Water Tank Cap (FIGURE 9-A). Do not turn unit upside-down
when Water Tank is full – some water may leak through air valve.
1. Make sure Steam Control Dial is set to "OFF" position.
2. Rotate Water Tank Cap one quarter turn in "Unlock" direction
(counter-clockwise) indicated by illustration on Cap, and remove.
3. Carefully fill Cup with maximum amount of water and pour into
water Tank through fill hole. Repeat up to two more times to fill
Water Tank to maximum capacity (Tank holds a maximum of 380
ml. of water).
NOTE: The tube which transfers water from the Water Tank to the
boiler is weighted down with a brass ball. This is an intentional
design to improve efficiency of water usage. It is normal for this
ball to create a rattling sound inside of Water Tank during use.
If you think brass ball has come loose from tube, refer to
Troubleshooting Guide for directions to reconnect it.
Operating the Multifunctional steam mop
NOTE: Be sure that Water Tank has been filled and all desired
accessories are connected before following these steps.
1. For first-time use, remove protective plastic cover that is shipped
on electrical plug, Plug power cord into a convenient electrical
outlet.
2. Turn Steam Control Dial clockwise from "OFF" position to one
of three settings: LOW, or HIGH, Power Indicator Light will
immediately illuminate to indicate that unit is powered on and
heating.
NOTE: The desired steam intensity setting depends on the
current steaming task.
Publicidad
