The space heater must be installed, adjusted, and used in conformity to national and local laws and regulations for its
operation.
General guidelines:
• Follow the instructions in this booklet very carefully;
• Do not install the heater in places where there is a risk of fire or explosion;
• Keep inflammable material at a safe distance from the heater (minimum 3 metres);
• Check that there is no overheating of walls, ceilings or floors made of inflammable materials.
• All fire prevention regulations must be complied with;
• All precautions have been taken to prevent fires;
• The premises in which the heater is installed are sufficiently ventilated for the burner requirements; in particular the
limits regarding the quality of the air in the room to be heated must be complied with, as prescribed by the applicable
national or local laws or, in the absence of any standards and/or indications, in compliance with the provisions of N
12669:2003.
• The generator is placed near a power switchboard having specifications that conform to those declared;
• Check the heater before switching it on and at regular intervals during its use;
• After use, make sure the disconnecting switch is off.
When using any type of space heater it is obligatory:
• not to exceed the maximum heat output level of the furnace ("TECHNICAL SPECIFICATION TABLE");
• make sure that the air flow is not below the rated level; check that there are no obstacles or obstructions to the air
suction and/or delivery ducts, such as sheets or covers on the equipment, walls or large objects near the heater.
Warning
This unit may not be used by persons (including children) with reduced physical, sensorial or mental capacities
or with limited experience and familiarity unless they are under supervision or instructed on how to use the
unit by the person responsible for its safety.
L-L 299.00-BM
EN
4. GENERAL ADVICE
58 / 116