STAMOS PROXUS 200D Manual De Instrucciones página 31

A - Button for switching functions of the left menu. Press and hold for 5 seconds to go to the data page.
B - Back button: takes you back to the higher-level menu or back. Press and hold for more than 5 seconds to
return to factory settings.
C - Value adjustment knob. Press to confirm the current setting.
D - Confirm button: press to enter a submenu or perform the current operation. Press and hold for more than 5
seconds to save the current data.
E - Button for switching functions of the right menu. Press and hold for more than 5 seconds to enter the data
storage page.
MIG/MAG torch
1 - gas nozzle
2 - gas distributor
3 - contact tip
4 - tip adapter
5 - torch neck
7. Connecting the wires
CAUTION! Connecting the cables to the device must be done with the power supply disconnected and the device
turned off.
Checking the tightness of gas connections
Before first use and then at regular intervals, it is recommended to check for gas leaks. The procedure should be
carried out as follows:
1) Connect the regulator and gas line assembly and tighten all connections and clamps.
2) Slowly open the cylinder valve.
3) Set the flow rate on the controller to approximately 8-10 l/min.