Publicidad
Idiomas disponibles
Idiomas disponibles
10) Close the spool housing cover.
CAUTION! When inserting the wire into the gun, do not point the gun at yourself or at other people. Do not place
your hand, e.g., in front of the tip, as the cut end of the wire is very sharp. Also, keep your fingers away from the feed
roller, as this may cause your fingers to be pinched between the rollers.
10.
Operation of the device
10.1.
Language setting
The welder offers several language options, so the operator can choose the preferred language.
10.2.
Setting the welding mode
�
�
Press the
(right) or
10.3.
Automatic mode
In the Auto mode, you can select the material, its thickness and wire diameter, then you can start welding. The machine
will propose the welding current, voltage and wire feed speed.
Note: If the material and thickness are set again, the system will revert to its default settings.
�
�
(left) button to select the desired welding mode, then press
Material selection
Turn the knob to select the welding material. The
number on the right corresponds to the fabric on
the left.
�
�
to go to the next step.
Publicidad
