Publicidad
Idiomas disponibles
Idiomas disponibles
Voltage selection ("Voltage")
The recommended starting value is "0". If the arc is
too short with this setting, increase the voltage. If
the arc is too long, reduce the tension.
Inductance
The recommended starting value is "0". If the arc is
very soft, set the inductance to a negative value; if
the arc is too hard, set it to a positive value.
Note: Inductance is selected by the system; if there
are no other special technological needs, there is no
need to change it.
Selecting the function "Peak feeding"
Adjust the value in the upper left corner to match
the actual thickness of the workpiece.
Selecting the dual pulse frequency
The recommended adjustment range is 1-2 Hz.
Publicidad
