Publicidad
Idiomas disponibles
Idiomas disponibles
4) Close the cylinder valve and watch the pressure gauge needle on the regulator. If the needle drops towards
zero, it means there is a gas leak. Occasionally, the gas leakage can be slow. To identify it, leave the gas
pressure in the regulator and the line for a long time (about 15 minutes).
5) In the event of a gas leak, check all connections and terminals for leaks. Brushing or spraying with soapy
water will cause bubbles to appear at the location of the leak.
6) Tighten clamps or couplings to eliminate gas leakage.
IMPORTANT! - It is recommended to check for gas leakage before starting the machine. It is recommended to close
the cylinder valve when the machine is not in use.
MMA welding mode:
1) Connect the welding cable to the connection marked with "+" and twist the cable plug to secure the
connection.
2) Connect the ground wire to the connection marked with "-" and twist the wire connector to secure the
connection.
3) Connect the power cord and turn on the power.
4) Connect the ground wire to the workpiece. Once these steps are completed, welding can begin.
CAUTION! Cable polarity may vary! All polarity information should be described on the package provided by
the electrode manufacturer!
TIG welding mode
1) Connect the ground cable to the connection marked with "+" and twist the cable plug to secure the
connection.
2) Connect the welding cable to the connection marked with "-" and twist the cable plug to secure the
connection.
3) Connect the gas line from the cylinder to the TIG torch (the cylinder should be equipped with a suitable
pressure regulator).
4) Connect the TIG torch control cable to the connector on the front panel of the machine.
5) Plug the power cord into an electrical outlet and start the machine.
6) Connect the ground wire to the workpiece. Once these steps are completed, welding can begin.
Welding using the MIG/MAG method
1) Insert the welding gun cable plug into the Euro MIG/MAG output socket on the front panel of the machine
and tighten it.
2) Insert the ground wire plug into the terminal marked "-" on the front panel of the welding machine and
tighten it clockwise.
3) Insert the polarity change plug into the terminal marked "+" on the welding machine's front panel and tighten
it clockwise.
4) Make sure that the correct welding wire is installed in the machine.
5) Connect the shielding gas cylinder with a pressure reducer to the gas inlet on the rear panel of the machine
using a gas hose.
6) Plug the power cord into an electrical outlet and start the machine.
7) Connect the ground wire to the workpiece. Once these steps are completed, welding can begin.
Welding using the FCAW method (without gas)
1) Insert the welding gun cable plug into the Euro MIG/MAG output socket on the front panel of the machine
and tighten it.
2) Insert the ground wire plug into the terminal marked "+" on the welding machine's front panel and tighten it
clockwise.
3) Insert the polarity change plug into the terminal marked "-" on the welding machine's front panel and tighten
it clockwise.
4) Make sure that the correct self-shielding welding wire is installed in the machine.
5) Plug the power cord into an electrical outlet and start the machine.
6) Connect the ground wire to the workpiece. Once these steps are completed, welding can begin.
Publicidad
