Publicidad
Idiomas disponibles
Idiomas disponibles
8. Replacing the drive roller
CAUTION! All maintenance, replacement of parts, repairs or adjustments should be carried out with the power supply
disconnected from the device.
Rolls available in the set:
1x Drive roller with V groove - for steel wires (Ø 0.8-1.0)
1x Drive roller with U groove - for aluminum wires (Ø 1.0 - 1.2)
If you need to change the wire diameter, also replace the drive roller or adjust the position of the drive roller.
1) Tilt the pressure adjustment lever to open the pressure roller.
2) Unscrew the drive roller mounting knob and make sure that the drive roller size is appropriate for the wire
being installed.
3) If necessary, pull the drive roller from the shaft and turn it to change the groove through which the welding
wire will move.
4) Reinstall the drive roller.
5) Tighten the drive roller mounting knob.
6) Close the pressure roller and set the pressure adjustment lever to the vertical position.
7) Adjust the pressure with the lever.
9. Replacing the welding wire
CAUTION! All maintenance, replacement of parts, repairs or adjustments should be carried out with the power supply
disconnected from the device.
1)
Open the housing of the machine and attach the spool of welding wire to the holder so that it rotates
counterclockwise.
2)
Unfasten the end of the wire from the spool and hold it in your hand at all times to prevent the spool from
unwinding.
3)
Straighten the end of the wire for about 20 cm and cut off the bent part.
4)
Open the pressure adjustment lever that opens the feeding mechanism.
5)
Guide the wire through the rear wire guide to the welding gun wire guide.
6)
Close the feeding mechanism and secure it with the pressure adjustment lever. Make sure that the wire
runs in the groove of the drive roll.
7)
Adjust the pressure of the lever, but do not exceed half of the scale. Too much pressure can damage the
wire. On the other hand, if the pressure is too weak, the wire will slide in the feed mechanism and the
wire will not move smoothly.
8)
Make sure that the contact tip suitable for the installed welding wire is inserted into the welding gun. If
necessary, replace the contact tip.
9)
Press the trigger of the welding gun and wait for the wire to come out.
CAUTION! Getting the wire out of the burner requires applying power to the unit.
Publicidad
