Kärcher BR 30/1 C Bp Manual De Instrucciones página 21

5. Remove the covers from the water
distribution strips.
Installation infor-
mation
Note the side markings on the covers
and on the device itself (L to L and R to
R).
6. Clean the covers under running wa-
ter.
7. Clean both of the water distribution
strips (circled in the illustration) us-
ing a damp cloth.
8. Check the fresh water inlet openings
(arrows) for contamination; remove
stubborn dirt with the cleaning brush
if necessary.
9. Assemble in reverse order.
Troubleshooting guide
Malfunctions often have simple causes
that you can remedy yourself using the
following overview. When in doubt, or
in the case of malfunctions not men-
tioned here, please contact your autho-
rized Customer Service.
The cleaning rollers do not turn and
the warning light illuminates
The safety switch-off function of the
drive motor has been triggered, e.g. as
a result of excessive pressure on the
cleaning rollers or due to an impact
against a wall or corner.
 Press the ON / OFF switch twice.
Only move the device back and forth
when cleaning; do not exert any
pressure on the device.
The cleaning rollers are jammed.
 Check whether the cleaning rollers
have been jammed by an object.
Remove the jammed object.
 Check if any dirt has accumulated in
the sweep bins and remove it (see
chapter Cleaning the sweep bins).
 Check to ensure the sweep bins are
inserted correctly. To do this, re-
move the sweep bins and insert
them again.
The device cannot be switched on
The battery pack is flat.
 Remove the battery pack from the
battery pack holder and charge it
(see chapter Finishing operation).
 Insert the charged battery pack into
the battery pack holder until it audi-
bly engages in place (see chapter
Inserting the battery pack).
The battery pack is not locked into the
battery pack holder.
 Insert the battery pack into the bat-
tery pack holder until it audibly en-
English 21