ABL Wallbox eM4 Twin Instrucciones De Uso página 25

x To disconnect the product completely from the electricity grid, the power supply must be inter-
rupted using the upstream safety switches and fault current protection devices in the domes-
tic power distribution.
x Ensure that the charging cable is not subjected to tensile stress at any time.
x Make sure that the product is always closed and locked when in use.
x Ensure that the charging cable is not driven over, kinked or pinched. Always treat charging
plugs, connectors and sockets with special care.
x Only have the product repaired by a qualified specialist electrical contractor authorised by ABL.
Charging procedure
The charging procedure is described below using the right-hand charge point as an example. For
the left-hand charge point, the steps are identical, but the status indicator is mirrored.
Proceed as follows:
1 Park your electric vehicle so that its charging inlet can be easily reached with the charging
cable's charging connector.
2 Check the status indicator of the charge
point. (Display: 1 cycle)
x When the charge point is ready for
charging, the status indicator pulsates
green.
3 Prepare the charging cable of the wallbox
and the vehicle's charging inlet.
J Open the charging inlet at the vehicle
and plug in the charging connector.
J Open the charging socket lid on the
wallbox and plug in the charging
connector.
4 Check the status indicator of the charge
point.
x When the vehicle is connected and
recognised, the status indicator lights
up static green.
|
Charging procedure 25