ABL Wallbox eM4 Twin Instrucciones De Uso página 27

x After successful authentication, the
wallbox emits two further short sound
signals and activates the charging
operation.
x If the authentication is not success-
ful, the status indicator for the charge
point lights up orange for a short peri-
od and the wallbox emits three long
sound signals.
x The blue chase light is then displayed
again: Hold a valid RFID card in front of
the status indicator.
NOTE
The authentication of the RFID card is not successful
If the RFID card could not be verified, do one of the following:
x Operating the wallbox with a backend: Please contact the issuer of the RFID card.
x Operating the wallbox without backend: Make sure that the RFID card has been
registered to the relevant wallbox. You can find further information in the comprehensive
installation manual.
ATTENTION
RFID card not readable
If the antenna of your RFID card is blocked or damaged, the card cannot be recognised.
x Remove the RFID card from its protective cover or card holder to register at the RFID
reader.
x Do not make any modifications to the RFID card: The card must never be perforated,
stamped, folded, have stickers attached, or otherwise be manipulated mechanically.
x Make sure that the RFID card corresponds to a standard that is supported by the wallbox.
You can find further information in the comprehensive installation manual.
|
Charging procedure 27