ABL Wallbox eM4 Twin Instrucciones De Uso página 26

NOTE
Authentication of the Wallbox eM4 Twin
Depending on the model version, the Wallbox eM4 Twin can be configured differently during
installation.
x Controller: A Controller can be operated as a stand-alone wallbox or with a backend.
x Controller with Extender: A Controller can be operated with one or more Extender wall-
boxes as a group in a backend or without a backend.
x Stand-alone Extender: An Extender configured for stand-alone operation is operated
without a backend.
If it is necessary to authenticate the charging operation via an RFID card, carry out the
following steps 5 to 7. If authentication is not required, go to step 8.
5 Check the status indicator of the wallbox
(display: 1 cycle).
x If the charging operation has to be
enabled using an RFID card, a blue
chase light is shown dynamically on
the status indicator.
x Anti-clockwise: right charge point
x Clockwise: left charge point
6 Hold a valid RFID card in front of the
status indicator.
7 Check the status indicator and acoustic
signals of the wallbox.
x If the RFID card has been read
successfully, the wallbox emits a short
sound signal and the wallbox checks
the authentication of the RFID card.
|
26 Charging procedure