ECOVACS DEEBOT T20 OMNI Manual De Instrucciones página 18

Wi-Fi Connection
Before Wi-Fi setup, make sure DEEBOT, mobile phone, and Wi-Fi
network meet the following requirements.
DEEBOT and Mobile Phone Requirements
• DEEBOT is fully charged and the power switch of DEEBOT is turned on.
• Wi-Fi status light slowly ashes.
• Turn off mobile phone's cellular data (you can turn it back on after setup).
Wi-Fi Network Requirements
• You are using a 2.4GHz or 2.4/5 GHz mixed network.
• Your router supports 802.11b/g/n and IPv4 protocol.
• Do not use a VPN (Virtual Private Network) or Proxy Server.
• Do not use a hidden network.
• WPA and WPA2 using TKIP, PSK, AES/CCMP encryption.
• WEP EAP (Enterprise Authentication Protocol) is not supported.
• Use Wi-Fi channels 1-11 in North America and channels 1-13 outside
North America (refer to local regulatory agency).
• If you are using a network extender/repeater, the network name (SSID)
and password are the same as your primary network.
After Wi-Fi connection, DEEBOT will enter into Networked Standby
mode if it has no signal input within 10 minutes.
Please be aware that the realization of intelligent functions such as remote
startup, voice interaction, 2D/3D map display and control settings, and
personalized cleaning (depending on different products) requires users to
download and use ECOVACS HOME App, which is constantly updated.
You need to agree to our Privacy Policy and User Agreement before we
can process some of your basic and necessary information and enable
you to operate the product.If you do not agree with our Privacy Policy and
User Agreement, some of the aforementioned intelligent functions cannot
be realized through ECOVACS HOME App, but you can still use the basic
functions of this product for manual operation.
EN 18
Charging DEEBOT
1
Assemble OMNI Station
2
OMNI Station Placement
Keep the area around the Station clear of objects.
* If there are re ective objects such as mirrors and re ective skirting lines near the
Station, the bottom 14cm of that should be covered.
Do not place the Station under direct sunlight.
It is recommended to place the Station on the hard oor to experience complete
functions of the robot.