Cleaning And Maintenance; Troubleshooting - cecotec Bongo Z Serie Manual De Instrucciones

DISPLAY
• ODO: Total km
• TRIP: Km run since the electric scooter has been turned on
• Battery level
• Speed (Km/h)
BATTERY CHARGING
NOTE: Make sure the device is turned off.
A. Open the charging port's cover located on the
right side of the vehicle and insert the 3-contact
power adapter's end.
B. Connect the other power adapter's end to a
wall power supply. The light indicator will turn
red during charge and will turn green when fully
charged.
Note:
• The device comes already charged, but it
is recommended to charge it for 6-8 hours
before the first use.
• It is also recommended to charge it after
each use and before storing it.
• To avoid the battery from damaging, do not
allow the vehicle to fully discharge.
THROTTLE AND BRAKE CONTROL
The throttle is located on the right handlebar
grip.
1. Press the throttle (1) towards yourself to
increase speed and release to decrease it.
2. Press the right or left brake of the handlebar
30
A
B
1
to brake.
3. The rear brake is located on the left side of the handlebar. Press it to brake with the rear
wheel.

6. CLEANING AND MAINTENANCE

CLEANING
• Clean the vehicle with a soft cloth, water and soap if necessary.
• After cleaning, dry thoroughly any metal parts subject to corrosion, oxidation, etc.
• The chain unit must be thoroughly cleaned and dried periodically to maintain the device
in good conditions for as long as possible.
• Lubricate the pivot points on the suspension.
OVERALL MAINTENANCE
• Maintenance should always be performed by qualified personnel.
• Always use spare parts provided by Cecotec.
• Any type of reparation must be carried out with the vehicle on the stand and turned off.
CHECKS TO BE CARRIED
• After a fall, check that the throttle grip operates correctly. To do so, try to accelerate and
decelerate a few times.
• From time to time, check that the brakes operate properly. To do so, move the vehicle
pushing it manually and brake suddenly to ensure they respond.
• Check all the parts of the vehicle are in place and securely assembled.
• Check the screws and chain tension.
• Check the wear of the tyres and their pressure.
• Check the wear of the brakes and the throttle cables.

7. TROUBLESHOOTING

ERROR CAUSE
The engine does not work. The battery is not connected. Check the connectors.
The battery is low.
Electrical problem.
SOLUTION
Recharge the battery.
Check all connectors.
31