Operation - cecotec Bongo Z Serie Manual De Instrucciones

• Do not race other drivers.
• A minimum safety distance of 5 m should be kept from other vehicles.
4. PRODUCT ASSEMBLY AND ADJUSTMENT
NOTE: The vehicle is shipped folded with the handlebar disassembled.
UNFOLDING THE SCOOTER'S STEM:
1. Pull up the stem while pressing down the rear fender.
2. Raise the stem, place the folding tab in a close position and turn the fixing ring to hold
the tab.
3. Fix the brake with an M6 hex wrench.
4. Paying attention to the rotation direction, tighten the handlebar.
FOLDING THE SCOOTER'S STEM:
1. Slide up the fixing ring to loosen it.
2. Open the folding tab.
3. Lower the folding tab and then the stem.
4. Align the closing hook with the gap on the rear fender and press it down to ensure it is
locked.
ACCESSING AND ACTIVATING THE BATTERY AND ENGINE
The battery and engine are already installed
and connected. To access to any of these, lift the
board. To activate the electric circuit, insert the
connector.
28
ADJUSTING THE FRONT AND REAR BRAKE
The brakes require periodic adjustment.
• The brake must be at a 5 or 6-mm distance from
the handlebar grip.
• Place yourself on the vehicle to verify the
distance between the handlebar grip and the
brake.
• If the distance exceeds the recommended one,
turn the washer on the brake (A) to adjust it.
• To adjust the brake cable's tension, adjust the
screw (B) on the rear wheel. This will allow
the wheel to spin freely when the brake is not
operated and will allow the vehicle to stop
immediately when it is pressed.
NOTE: After each adjustment, tighten the locknut.

5. OPERATION

PUSH BUTTONS
• Power switch: Hold down this push button for a few seconds to turn the scooter on or off.
• Throttle: Use it to start the scooter and to accelerate.
• Brake: Hold it down to stop.
• Function: Press this push button twice to adjust speed. Select between:
• ECO mode – Eco appears on the display.
• COMFORT mode – S appears on the display.
• SPORT mode – S+ appears on the display.
• Headlight: Press the function button once to turn the headlight on. The back lights are
always on. While the lights are on, short press the function push button once to turn
them off.
NOTE: The back light will blink when using the brakes.
A
B
29