Publicidad
Idiomas disponibles
Idiomas disponibles
Using the IPM-400 to Read (cont'd)
Check Continuity
Display: Ω, CONTINUITY
This function checks continuity.
1.
Turn the Selector knob to
2.
Connect the black and red leads to the meter as shown.
3.
Press the DISPLAY/SOURCE/READ button until "READ" or "CONTINUITY" appears.
4.
Press the TYPE/ENG UNITS button to select "CONTINUITY".
5.
Disconnect one or both input wires from the device being calibrated.
6.
Connect the red (+) lead and the black (–) lead of the meter across the resistance to be
measured. A tone sounds and
the leads is less than approximately 100 Ω.
All manuals and user guides at all-guides.com
.
appears on the display when the resistance between
IPM-400
29
Publicidad
