2
12
En
All manuals and user guides at all-guides.com
Connecting Up
Connecting the Super Woofer
speakers
XR-A790 only: Use the supplied blue and black speaker
cords to connect the Super Woofer speakers to the main unit. Like
the front speakers above, it's important that you connect the two
strands of speaker cord for each speaker to the correct speaker
terminal.
Connect the Super Woofer speaker cords in the same way as the
front speakers above.
Note: Make sure that the bare speaker wires cannot touch each
other, or come into contact with other metal parts once the unit is
switched on.
Connecting the rear speakers
XR-A790 only: The rear speakers connect to the main unit
by RCA/phono-type plugs. Simply plug each speaker into the
corresponding jack on the rear panel. Use only speakers with a
nominal impedance of between 16 Ω or more.
To mount the rear speakers on a wall:
• Use the hole located on the rear panel of the speaker to mount
it on a wall. Make sure that the speakers are mounted securely
to prevent accidents.
• Check that the wall is strong enough to hang the speakers on.
Pioneer disclaims any responsibility for damage due to falling
speakers and other accidents caused by inappropriate strength
of the wall or improper installation.
• No screws or other fittings are supplied to mount the speakers
on the wall.
Speaker Caution!
Do not connect any of the supplied speakers to any other
amplifier. This may result in malfunction or fire.
If you wish to connect speakers other than the ones supplied with
this system, use only speakers with a nominal impedance of
between 12–16 Ω with the XR-A790, and between 6–16 Ω with
the XR-A390. Refer to the instructions that came with your
speakers if you are unsure of their impedance before connecting
them and switching on.
Placing the speakers
Where you put your speakers in the room has a big effect on the
quality of the sound. The following guidelines and the diagram
below should help you to get the best sound from your system.