Publicidad
Idiomas disponibles
Idiomas disponibles
10
TAPE
STANDBY/ON
JOG
Function select buttons
功能選擇按鈕
Teclas de selección de función
56
En
All manuals and user guides at all-guides.com
TUNER/BAND
AUX
CD
JOG
TIMER/CLOCK ADJ
SET
Using the Timer
Setting the wake-up timer
The clock must be set to the correct time for the wake-up timer to
work properly.
Use the wake-up timer to set a time for the system to switch on
and start playing your choice of source. The wake-up timer
remains active (so the system will switch on everyday at the time
you set), until you reset it.
Also, you cannot set both the wake-up and the record
Note:
timer.
Use the front panel controls to set the timer:
1 Select the source you want to wake up to.
For example, press
/
TUNER
source.
2 Prepare the source.
For example, tune in the radio station.
If you've selected a CD or tape, make sure that it's stopped.
3 Set the volume.
4 Press TIMER/CLOCK ADJ.
5 Turn the JOG dial until the display shows TIMER, then
press SET.
6 Set the switch-on time.
Use the
dial to set the hour, then press
JOG
in the same way, pressing
SET
7 Set the switch-off time.
Use the
dial to set the hour, then press
JOG
the same way, pressing
SET
The switch-on and switch-off times are confirmed in the display
after pressing
this last time.
SET
8 Switch the system into standby mode.
9 Press TIMER/CLOCK ADJ.
10 Turn the JOG dial until the display shows WAKE UP,
then press SET.
The timer standby indicator ( ) lights in the display and wake
up timer setup is complete!
Note: There is no way to edit the timer settings once made. If
you make a mistake, work through the rest of the settings, then
start over.
to select the radio as your
BAND
. Set the minute
SET
when you're done.
. Set the minute in
SET
when you're done.
Publicidad
