Publicidad
Service & maintenance information
Service and maintenance of a medical device is wholly the responsibility of the owner of that device.
Failure to service and maintain a device in accordance with the instructions may invalidate the device's
warranty. Furthermore, failure to service and maintain a device may compromise the clinical condition
or safety of users and/or their caregivers. Do not perform service and maintenance while the user is in
the product. Contact the local dealer for assistance, if needed, in setting up, using or performing service
and maintenance of the device.
Lifetime
The lifetime of this product in normal use is 8
years if all maintenance and servicing is carried
out in accordance with the manufacturer's
instructions and demonstrably recorded. The
device may be reissued within its lifetime.
Service interval
The frequency of inspection may be altered
depending upon use and wear. It is recommended
that the product is inspected yearly, every time
the product is re-issued for use and after a
long-term storage (more than 4 months). The
inspection should be carried out by a person who
understands the use of the product.
Service checklist
According to their intended use, check:
• that the nuts and bolts on the product are
tightened
• the product for cracks or signs of worn out
parts
• that all labels on the product are intact
• that all accessories, attachments and
functions on the product are intact
• the adjustment options for the foot rest
and that it is possible to lock the angle and
fasten the telescopic tubes in position
• that the seat back is adjustable and can be
locked in position
• that the seat plane is adjustable and stays
in position after adjustment
• that the frame is adjustable in height
• that the powered versions are able to retain
power after charging the battery
and adjust if necessary.
Repair or replace any damaged or worn out parts.
Maintenance
Before every use it is recommended to:
• Wipe off any residue and dirt from the
product using a cloth wrung in warm water
and a mild detergent/soap without chlorine
and dry before use
• Carry out a visual inspection, for any
damaged or worn-out parts.
Washing
Main product
This product can be washed at 60° using a mild
detergent for 10 minutes in a washing machine
designed for medical devices. Use the machine's
drying function to dry the product. Unmount all
etac.com
EN
XX
accessories and wash them separately.
Before washing
Avoid degreasing of the piston rods, the actuators
should be retracted to minimum stroke.
• Remove all accessories, unplug all cables
and make sure to dismount the power unit.
• Do NOT clean the power unit with a high
pressure cleaner or steam cleaner.
After washing
• Ensure correct installation of the power unit.
• Check that the handset functionalities works
correctly
Fabric and covers
The cushion covers can be washed at 60°C
using a mild detergent in a washing machine.
For the remaining fabric and covers, check each
item's care label for specific instructions.
Separate foam and cover before wash.
Foam
The following foam inserts can be washed
at 40°C using a mild detergent in a washing
machine:
• Seat cushion foam inserts
• Back cushion foam inserts
During and after washing the foam, do not bend,
squeeze or wring it, as it may negatively affect
the shape.
It is not recommended to wash other foam parts.
Handwash
This product and its accessories can also be
washed by hand. Use warm water and a mild
detergent/ soap without chlorine and let all parts
dry before use.
Disinfection
The product can be disinfected with a 70%
disinfectant IPA solution. Before disinfection, it is
recommended to wipe off any residue and dirt
from the product, with warm water and a mild
detergent/soap without chlorine, and let it dry.
Materials
• Steel
• Stainless steel
• Plastic: ABS, PE, PA6+GF30, TPU, POM,
PA6+GF15
• Polyurethan
Surface treatment
The following surface treatment processes were
used to protect against corrosion:
49
Publicidad
