Publicidad
• mount the most suitable brushes or drive disks for the floor and work to be performed
(see paragraph 3.4);
• make sure the squeegee (fig. E) is firmly attached and connected to the suction hose
(fig. E, ref. 2). Make sure the back blade is not worn.
If you are using the machine for the first time, we recommend trying it on a large
obstacle-free surface first to acquire the necessary familiarity.
Always empty the dirty water tank before filling the detergent tank again.
For effective cleaning and to extend the working life of the machine, follow a few simple
rules:
• prepare the work area by removing all possible obstacles;
• begin working from the furthermost point to avoid walking on the area you have just
cleaned;
• choose the straightest possible working routes;
• divide large floors into parallel rectangular sections.
If necessary, finish off by passing a mop or rag rapidly over parts inaccessible to the
scrubber drier.
6.7.
Working
The seat (fig. D, ref. 3) has a safety sensor which allows the machine to move only
The machine (CT 230 only) has a safety system to prevent it tipping over. This
reduces the speed on bends, irrespective of the pressure exerted on the machine
movement pedal. This reduction of speed on bends is therefore not a malfunction,
but a feature which increases the machine's stability in all conditions.
When the machine movement pedal is released, all functions shut down
automatically within 5 seconds (Auto Power-Off). While the machine is in stand-by,
the light corresponding to the set programme will flash.
functions, just move the machine without deselecting the set programme (Auto
Power-On).
After setting up the machine, proceed as follows:
• start the machine by turning the key (main switch) clockwise (fig. B, ref. 3).
• Select the most suitable programme from the three available. Pressing one of the work
programme buttons activates all the functions of the chosen programme (brush motors
and suction motor on).
• P1 (fig. B, ref. 1) light wash programme for smooth not excessively dirty floors.
• P2 (fig. B, ref. 15) medium wash programme for smooth floors with evident dirt.
• P3 (fig. B, ref. 2) heavy wash programme for rough floors (concrete etc.) with
stubborn dirt.
ENGLISH
16
i INFORMATION
i INFORMATION
when the operator is seated.
i INFORMATION
i INFORMATION
To reactivate the
Publicidad
