Publicidad
10.
To change the default settings, proceed as follows.
With the machine on but no function active, press the settings button (fig. B, ref. 4) for at
least 5 seconds. You can now vary the parameters below in the following order:
1. LANGUAGE: select using the "+" and "-" buttons (fig. B, ref. 5). Press the settings
button (fig. B, ref. 4) to save the setting then move on to the next parameter.
2. PROGRAMME 1 BRUSH PRESSURE FROM 010 TO 100: change using the "+"
and "-" buttons (fig. B, ref. 5). Press the settings button (fig. B, ref. 4) to save the
setting then move on to the next parameter. DEFAULT = 030
3. PROGRAMME 1 BRUSH ENABLING ON-OFF change using the "+" and "-"
buttons (fig. B, ref. 5). Press the settings button (fig. B, ref. 4) to save the setting
then move on to the next parameter. DEFAULT = ON
4. PROGRAMME 1 SUCTION MOTOR ENABLING ON-OFF change using the "+"
and "-" buttons (fig. B, ref. 5). Press the settings button (fig. B, ref. 4) to save the
setting then move on to the next parameter. DEFAULT = ON
5. PROGRAMME 1 WATER DELIVERY: change using the "+" and "-" buttons (fig. B,
ref. 5). The following values can be set:
OFF, when the programme is run, water delivery is not active
Lev. 1, pump active at 18% of working cycle
Lev. 2, pump active at 36% of working cycle
Lev. 3, pump active at 45% of working cycle
Lev. 4, pump active at 60% of working cycle
Lev. 5, pump active at 75% of working cycle
Lev. 6, pump active at 100% of working cycle
AUTO, pump active in proportion to working cycle of drive
Up to 16% speed, pump 18% active
Up to 32% speed, pump 36% active
Up to 50% speed, pump 45% active
Up to 65% speed, pump 60% active
Up to 80% speed, pump 75% active
More than 80% speed, pump 100% active
Press the settings button (fig. B, ref. 4) to save the setting then move on to the
next parameter.
DEFAULT = 2
6.
PROGRAMME 1 SPEED: maximum drive speed. The parameter can be varied
from 010 to 100. It can be changed using the "+" and "-" buttons (fig. B, ref. 5).
Press the settings button (fig. B, ref. 4) to save the setting then move on to the
next parameter. DEFAULT = 100
7. PROGRAMME 1 POWER ENABLING ON-OFF: change using the "+" and "-"
buttons (fig. B, ref. 5) Press the settings button (fig. B, ref. 4) to save the setting
then move on to the next parameter. DEFAULT = ON
8. DETERGENT FLOW: the detergent flow can be changed using the "+" and "-"
buttons (fig. B, ref. 5). Press the settings button (fig. B, ref. 4) to save the setting
then move on to the next parameter.
For PROGRAMMES 2 and 3, use the above procedure. To exit the settings
menu, hold the settings button (fig. B, ref. 4) down until battery voltage is
displayed.
CONFIGURING THE SCRUBBER DRIER
ENGLISH
23
Publicidad
