Publicidad
8
A
8
8
122
5-60b
5-61
5-62
5-63
Operation
Figure 5-60b OPTIMISATION "10", outside
Rotate the wheel into marking position following the
arrows.
In this position make a double mark on the tyre
outer side exactly perpendicular to and above the
chuck.
Confirm by pressing key 8.
The OPTIMISATION "11" screen appears (Fig. 5-62).
Figure 5-61 OPTIMISATION "10", inside
If the wheel cannotbe turned over on the rim (e.g.:
Asymmetrical and Directional),
press key (A, Fig. 5-61), then
continue as shown on screen OPTIMISATION
"10" (Fig. 5-60b).
If the wheel can be turned over on the rim;
Rotate the wheel into marking position following the
arrows.
In this position make a double mark on the inside
of the tyre, exactly perpendicular to and above the
chuck.
Turn the tyre over on the rim (tyre changer).
Confirm by pressing key 8.
The OPTIMISATION "11" screen appears (Fig. 5-62).
Figure 5-62 OPTIMISATION "11"
Push the tyre on the rim until the double mark
coincides with the valve (use tyre changer).
Confirm by pressing key 8.
The OPTIMISATION "12" screen appears (Fig. 5-63).
Publicidad
