Publicidad
48
Operation
5.1.2
Status at switching on
The electronic unit is factory-adjusted to the following
operating modes, available after switch on:
– AUTOMATIC Operating Mode
– Wheel type 1 (car wheel with nominal dimensions
in inches, width 6.5" and diameter 15.0").
– Acquisition of rim data, unit of measurement:
inches.
– Display of unbalance value with 5 gram increments.
– Suppression of minor unbalance shown (tolerance
limit set at 3.5 grams).
– Automatic rotation stop when wheel guard is
opened during the measuring run.
– Compensation of adaptor unbalance switched off.
– Starting the measuring run by closing the wheel
guard.
Only for models with wheel lifter:
– Machine operation enabling, after start up, depends
on activation with the control pedal.
5.1.3
Shutting down
Always shut down properly when work is complete:
Remove the wheel from the balancer.
Remove the cones from the stub shaft. Check
the surfaces (internal and external) of the cones
for damage. The conditions of the cone are very
important for a good balance quality.
Clean the cones, nut and stub shaft with a soft, dry
cloth.
Place the cones and the quick nut in the correct
position.
Unplug the mains cable from the power outlet.
Check the power cable for damage or wear.
Tidy up the storage areas.
Clean the display and input panel with a soft, dry
cloth.
Check that the balancer is only resting on its own
three feet. Remove old wheel weights taken off
and any other materials which could get under the
balancer.
Publicidad
