Publicidad
8
8
8
128
5-69b
5-70
5-71
5-72
5-73
Operation
Figure 5-69b MINIMISATION "3"
Rotate the wheel into marking position following the
arrows.
In this position mark the tyre, on the outer side of
the wheel, precisely above the chuck.
Confirm by pressing key 8.
The MINIMISATION "4" screen appears (Fig. 5-70).
Figure 5-70 MINIMISATION "4"
On the tyre changer, turn the tyre with respect to
the rim until the valve is aligned with the mark made
on the tyre.
Confirm by pressing key 8.
The MINIMISATION "5" screen appears (Fig. 5-71).
Figure 5-71 MINIMISATION "5"
Clamp the wheel.
Rotate the wheel until the valve is exactly
perpendicular to and above the chuck.
Confirm the valve position by pressing key 8.
The MINIMISATION "6" screen appears (Fig. 5-72).
Figure 5-72 MINIMISATION "6"
START is signalled on the screen
Perform the wheel measuring run.
A measuring run is performed.
The MINIMISATION "7" screen, outside, is displayed
(Fig. 5-73) or the MINIMISATION "7" screen, inside,
appears (Fig. 5-75).
Indication H 0
Optimum condition has been achieved and cannot be
further improved.
Continue as shown on screen BALANCING (Fig.
5-65).
Publicidad
