Denon PMA-1500RII Instrucciones De Operación página 12

ENGLISH DEUTSCH
4 REMOTE CONTROL OPERATION
The accessory Remote Control Unit is used to control the amplifier from a convenient distance.
■ Inserting the Dry Cell Batteries
1. Remove the battery cover on the Remote Control Unit.
2. Insert two dry cell batteries as shown in the diagram on
the battery supply unit.
3. Replace the battery cover.
■ Directions for use
Approx. 8 m
Note on operation
• Do not press the operating buttons on the Amplifier and the Remote Control Unit at the same time. This will cause misop-
eration.
• Operation of the Remote Control Unit will become less effective or erratic if the infrared Remote Control Sensor on the
Amplifier is exposed to strong light or if there are obstructions between the Remote Control Unit and the sensor.
• In case you operate a VCR, TV or other components by remote control, do not operate buttons on two different remote
control units at the same time. This will cause misoperation.
Besides being able to operate the PMA-1500RII Integrated-amplifier with this Remote Control Unit,
12
FRANCAIS ITALIANO
you can also operate a DENON cassette deck, MD recorder, tuner and
CD player with this handy full-system Remote Control Unit.
ESPAÑOL NEDERLSNDS
Notes on Battery Usage
■ RC-885 uses the size R6P (AA) dry cell batteries.
■ The batteries will need to be replaced approximately
once a year. This will depend upon how often the
Remote Control Unit is used.
■ If, in less than a year from the time new batteries were
inserted, the Remote Control Unit fails to operate the
Amplifier from a near-by position, it is time to replace the
batteries.
■ The included battery is only for verifying operation.
Replace it with a new battery as soon as possible.
■ Insert the batteries properly, following the polarity dia-
gram inside the battery compartment.
■ Batteries are prone to damage and leakage. Therefore:
• Do not mix new batteries with used ones.
• Do not mix different types of batteries.
• Do not jumper opposite poles of the batteries, expose
them to heat, break them open, nor expose them to
open fire.
■ If the batteries have leaked, remove any traces of battery
fluid from the battery compartment wiping thoroughly with
a dry cloth. Then insert new batteries.
■ Operate the Remote Control Unit while pointing it
towards the Remote Control Sensor on the Amplifier as
shown in the diagram on the left.
■ The Remote Control Unit can be used at distances up to
about 8 meters in a straight line from the amplifier. This
distance will decrease if there are obstructions blocking
the infra-red light transmission or if the Remote Control
Unit is not directed straight at the amplifier.
SVENSKA PORTUGUÊS