Publicidad
1. O-ring
1. Joint torique
1. Junta tórica
1. Oil filter cartridge
1. Cartouche de filtre à huile
1. Cartucho del filtro de aceite 2. Llave dinamométrica
2. Torque wrench
2. Clé dynamométrique
5. Apply a light coat of engine oil to the O-ring of
the new oil filter cartridge.
NOTE:
_
Make sure the O-ring is seated properly.
_
6. Install the new oil filter cartridge with an oil fil-
ter wrench, and then tighten it to the specified
torque with a torque wrench.
Tightening torque:
Oil filter cartridge:
17 Nm (1.7 m·kgf, 12 ft·lbf)
7. Install the engine oil drain bolt, and then tight-
en it to the specified torque.
Tightening torque:
Engine oil drain bolt:
30 Nm (3.0 m·kgf, 22 ft·lbf)
8. Add the specified amount of recommended
engine oil, and then install the engine oil filler
cap and tighten it.
8-29
Publicidad
