Built-in installation
IMPORTANT: The unit must be correctly installed in accordance with the
manufacturer's instructions and by qualified person. Maintenance and service must
be carried out after the power supply has been disconnected.
ELECTRICAL CONNECTION: Before connecting the appliance to the mains,
ensure that:
• The voltage corresponds to the voltage specified on the rating plate at the bottom
of the surround.
• The overload cut-off device and the domestic system can withstand the load of the
appliance (see rating plate).
• The power supply system is provided with an efficient earth connection and that
the socket or omnipolar switch, with minimum contact opening of 3mm, is easily
accessible once the appliance has been installed.
• If the plug is not easily accessible, the installation personnel must provide an
omnipolar switch with contact opening distance equal to or greater than 3mm.
If further mains cable is needed, it must be with a minimum section of 1,5 mm - type
H05RR-F. Sufficient cable must be left for easy maintenance of the appliance.
Warning: this appliance must be earthed.
Our company declines any liability for failures in the earth connection that is not in
compliance with the regulation in force.
This appliance is designed for building-in to a standard 600mm wide oven housing.
The housing, adjacent furniture and all materials used in installation must be able to
withstand a minimum temperature of 85°C plus ambient temperature during periods
of operation.
In addition, adjacent furniture cabinet doors must be at least 4mm from the
appliance at all points.
Certain types of vinyl or laminate kitchen furniture cabinetry are particularly prone to
heat damage and discoloration, any delimitation or discoloration of materials which
occurs below 85°C plus ambient temperature or where materials are less than 4mm
from the appliance will be the liability of the owner. For building-under a worktop,
the installation dimensions are as follows.
Attention : when the qualified person install the oven near other electrical
appliances, the power cable mustn't be near or contact with side heat oven.
35