Publicidad
Idiomas disponibles
Idiomas disponibles
English / USA
7
6
8
:
Loosen the screw (6) and remove it
with the washer.
:
Push the control handle (7) – throttle
trigger must face gearhead – on to
the handlebar (8) so that the holes
(9) line up.
:
Insert screw with washer and
tighten it down firmly.
To save space when transporting or
storing the machine, loosen the
clamp screw and hex. head screw
and swing the handlebar in line with
the shaft, fold the handles down.
18
Throttle Cable Adjustment*
On control handles with slide*:
:
Go to chapter "Adjusting the
Throttle Cable".
7
9
*
see "Guide to Using this Manual"
Adjusting the Throttle Cable
Some machine versions are equipped
with a throttle cable adjuster in the
control handle.
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled – the
control handle must be in the normal
operating position.
:
Use a suitable tool to push the slide
to the bottom of the slot (see
illustration).
FS 500, FS 550
Publicidad
