Publicidad
Idiomas disponibles
Idiomas disponibles
Pass
the
(22.3
rod
through
Insert the washer and
0.5 inch (1.3 cm) screw
on opposite side and
tighten ❹.
TIP: If connector rod does not pass through easily, make
sure it is aligned with holes and tap screw head
lightly to guide it through the plastic.
!
WARNING: Ensure that all THREE connection points
are secure and tight. DO NOT over tighten.
CHECK FREQUENTLY.
INSTALLING CHILD RESTRAINT IN HARNESS
MODE: LATCH OR VEHICLE SEAT BELT
You can install the child restraint using EITHER the
LATCH or vehicle seat belt.
LATCH: The Lower Anchors and Tethers for CHildren
(LATCH) is used for installing the child restraint WITHOUT
using the vehicle seat belts.
!
The LATCH can ONLY be used if your vehicle has the
LATCH anchors installed and designated LATCH seating
positions. Check your vehicle owner's manual to see
which seating positions may be equipped with LATCH.
Vehicle Seat Belts: If LATCH is not an option, you MUST
use the vehicle's lap-only or lap-and-shoulder belt to
install the child restraint in your vehicle.
8.8
cm)
connector
assembly.
inch
Connector
screw
Backrest
anchor points
❹
Base
plate
22
Publicidad
