Publicidad
Idiomas disponibles
Idiomas disponibles
!
CAUTION: Reinstall harness system if applicable
(see "Removing/Installing harness", pg. 37).
1. The cup holder can be installed on
either side of the child restraint.
2. Locate the opening in the end of
either armrest.
3. Insert cup holder clip into the
opening and push in until locked
into place. Ensure that the fabric
does not interfere with the installation. If so, gently
pull down on the fabric while installing cup holder.
4. Pull out to remove.
CLEANING YOUR SEAT PAD:
• MACHINE WASH SEPARATELY using cold water -
delicate cycle.
• DO NOT BLEACH.
• DRIP DRY to prevent cover from shrinking.
!
DO NOT wash EPE foam pad insert in backrest.
CLEANING THE PLASTIC SHELL:
• SPONGE CLEAN using warm water and mild soap.
• TOWEL DRY.
• DO NOT use solvents, abrasive cleaners, or
disassemble child restraint in any way, except as
instructed.
CLEANING HARNESS AND LATCH STRAPS:
• Spot clean with a damp cloth. DO NOT BLEACH.
DO NOT immerse the straps in water. Doing so may
weaken the straps.
INSTALLING CUP HOLDER
(WHEN APPLICABLE)
CARE AND MAINTENANCE
46
Publicidad
