Caster/Forks Assembly (Fig.4.3); Dual-Post Armrests (Fig.4.4 - 4.5); Height-Adjustment; Height-Adjustable Armrests (Optional) - Quickie SR 45 Manual De Instrucciones

Ocultar thumbs Ver también para SR 45:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 119

CASTER/fORKS ASSEMbLY (fIG.4.3)

Installation
Remove dust cover (A) from caster housing. Pry cover
off using a back and forth motion.
Caster assembly holds one nut (B) and one washer
(immediately below the nut). Remove nut and
washer.
Insert caster stem (C) into caster housing (D) and
place washer on stem.
Replace nut (B) on caster stem and tighten until all
play is removed; then loosen approximately 1/8 turn,
allowing for free rotation.
Replace dust cover to caster housing.
height Adjustment
Loosen and remove bolt (E).
Set axle at desired height using pre-set holes in the
fork.
Replace and tighten bolt.
Repeat on other side.
NOTE: The frame must be kept horizontal when height is
adjusted. Refer to page 26 for rear axle height
adjustment.

DuAL-PoSt ARMReStS (fIG.4.4 - 4.5)

Installation and Removal
The assembly is held securely in place when the
securing lever (F) is facing rearward.
Push front securing lever (F) down to release, or lift
transfer bar lever (G), whichever is present.
Completely press lever (H) inward on rear post.
Lift armrest out of receivers.

height-Adjustment

Release the upper securing lever (I).
Set armrest at desired height.
Return securing lever to locked position.
Move armrest up or down to allow armrest to snap
into place.
flip back (optional)
Release the front securing lever (F) or lift up transfer
bar lever (G), whichever is present.
Flip the armrest back, it remains attached to the rear
receiver.
To detach armrest completely press lever (H) inward
on rear post and lift up.
To reattach, move armrest down into place.
Return securing lever (F) to locked position (if
applicable).
Fig.4.3
A
B
c
D
SR45 Rev.1.0

hEIGhT-ADJUSTAbLE ARMRESTS (OPTIONAL)

(Fig.4.6)
Installation
Slide the outer armpost into the receiver mounted to the
wheelchair frame.
The armrest will automatically lock into place.
height Adjustment
Rotate release lever to second stop.
Slide armrest pad up or down to desired height.
Return lever to locked position against armpost.
Push arm pad until upper armpost locks firmly into place.
Removing Armrest
Rotate release lever to first stop and remove the armrest.
Replacing Armrest
Slide armrest back into receiver.
Return release lever to locked position against armpost.
Adjusting Armrest Receiver fit
To tighten or loosen the fit of the outer armpost in the
receiver:
Loosen the bolts on the sides of the receiver (9).
With the armrest in the receiver, squeeze the receiver to
achieve the desired fit.
Tighten the four bolts.
Fig.4.6
1. Outer arm post
2. height-Release Lever
3. Release lever
4. Arm rest pad
5. Transfer bar
e
6. Side panel
7. Receiver
8. Clamp
9. Receiver adjuster bolts
Fig.4.4
f
Fig.4.5
G
4
6
2
3
1
7
I
h
I
h
5
8
9
21

Publicidad

Tabla de contenido
loading

Tabla de contenido