CASO DESIGN ProAdvanced E1 Manual Del Usuario página 38

DE
6.2 Cleaning
EN

Ceramic hob
FR
Wipe the glass ceramic hob with a damp cloth or using a mild, non-abrasive soap solution.
IT

Housing and Operating Panel
ES
Clean the hob, the housing of the device and the operating panel with a soft, slightly
damp cloth.
NL
ATTENTION
RUS

Verwenden Sie keine lösungshaltigen Reinigungsmittel wie z.B. Benzin, um die
SE
Kunststoff teile nicht zu beschädigen.
PT
7 Troubleshooting
This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
7.1 Safety notices
ATTENTION

Repairs of electrical appliances must be carried out by qualifi ed person who are
trained by the manufacturer.

Repairs performed by untrained persons may result in considerable hazards for the
user and damage the machine.
7.2 Troubleshooting table
The table below will help you to locate and solve small problems.
Display
No display Mains plug not plugged in or fuse not switched on. Plug in the mains
––
E01 / E02
E05
PLEASE NOTE

If you cannot solve the problem by carrying out the steps described above, our Cus-
tomer Service will help you free of charge.

Clean the device before you send it to customer service.
38 CASO ProAdvanced E1
Description
plug or switch on the fuse.
There is no pot on the hob, or the pot size/material is not suitable.
The overvoltage or undervoltage protection has tripped. Connect the
unit to a suitable power supply.
Overheating Protection
This means that the temperature had increased to a temperature of
270 °C. In this case the device turns off automatically in order to avoid
damages. In case of "E05" please pull the power plug in order to reset the
device. After this you can use it again as usual.