Functions; Piece Counting; Percent Weighing - Mettler Toledo AL Serie Instrucciones De Manejo

5 Functions

Settings and values saved under a given function are retained until they are replaced or another function is selected. The «C» key
can be used to cancel the procedure currently in progress.

5.1 Piece counting

0. 0 0 g
# # # # #
SEt 10
F
SEt 20
" " "
" "
20
± ± ±
± ±
240
144. 8 1 g
" " " " "

5.2 Percent weighing

0. 0 0 g
148. 5 0 g
SEt100
F
100. 0 0
± ± ±
± ±
Requirement
The function "F count" must be activated in the menu (Section 4).
➞ Place empty container on the balance and tare by briefly pressing the
«# # » key.
# #
#
Setting the reference: a reference weight must first be entered for piece counting:
➞ Add a number of reference pieces to container. Possible numbers are 5, 10, 20,
50, 100 and "no" (piece counting deactivates).
Note that the minimum weight = 10d (d: display increment), and the minimum
unit weight = 1d!
➞ Hold the «F» key down until "SEt ... PCS" is displayed.
PCS
➞ Repeatedly press the «"
reference pieces entered.
PCS
➞ Confirm the number of reference pieces with the «±
acceptance after 7 seconds. The current number of pieces (PCS = pieces) is
PCS displayed.
Switching between piece count and weight display
PCS
➞ Place the items to be counted in the container. The number of pieces is
displayed.
➞ Press the «"
again, in unit 2, provided this function is activated).
➞ Return to the piece count display by pressing the «"
Requirement
The function "F 100 %" must be activated in the menu (Section 4).
Set target weight
➞ Target weight (Reference weight, which corresponds to 100 %) in centre of
pan.
%
Note that the minimum weight = 10d (d: display increment).
➞ Hold the «F» key down until "SEt 100 %" is displayed.
%
➞ Press the «"
deactivated).
➞ The «±
± » key can be used briefly to confirm or automatic acceptance after 7
± ± ±
seconds.
" » key until the display equals the number of
" "
"
" » key. The weight is displayed (in unit 1, and if the key is pressed
" "
"
" » key to select "SEt 100 %" or "SEt no %" (Percent weighing
" " "
Functions
17
± » key or automatic
± ±
±
" » key again.
" " "