Tunturi T50 Treadmill Manual Del Usuario página 27

rating and the treadmill is the only appliance
on the circuit) but the circuit breaker on the
treadmill itself does not trip, you will need to
replace the breaker with a high inrush type. This
is not a warranty defect. This is a condition we as
a manufacture have no ability to control.
Unfolding and folding the
equipment (fig. F1-F2)
The equipment can be unfolded for use (fig. F1) and
folded for transport and storage (fig. F2).
Refer to the illustrations for the correct way of unfolding
and folding the equipment.
CAUTION
• Before folding the equipment, make sure that
the incline is 0%. If the incline is not 0%, folding
will damage the mechanism.
Console (fig. E-1)
CAUTION
• Keep the console away from direct sunlight.
• Dry the surface of the console when it is covered
with drops of sweat.
• Do not lean on the console.
NOTE
• The console switches to standby mode when
the equipment is not used for 4 minutes. If the
console is in standby mode, the display shows
the room temperature
Buttons
Stop/ Reset button:
- Stop the active training.
- Reset console when press and hold for 2 seconds in
"stop mode"
Dial/ Quick start
- Press Dial at any time when being in Idle mode to
start your workout, with or without pre-set settings.
- Turn to adjust parameter in programming mode.
- Turn to adjust speed in workout mode.
- Press dial to wake-up console when being in Stand-
by mode.
Speed + (Hare)
- Increases the speed (0,8~18 Kph).
- Pressing once increases the speed 0,1 kph.
- Pressing and holding for two seconds will increase
the speed faster.
- Scroll programs and change values in programming
mode.
Speed - (Turtle)
- Decreases the speed (0,8~18 Kph).
- Pressing once decreases the speed 0,1 kph.
- Pressing and holding for two seconds will decrease
the speed faster.
- Scroll programs and change values in programming
mode.
Incline +
- Increases the incline (0%~12% ±1%).
- Scroll programs and change values in programming
mode.
Incline -:
- Decreases the incline (0%~12% ± 1%).
- Scroll programs and change values in programming
mode.
MODE/ ENTER
- Select program mode
- Confirm setting to enter next step in programming
mode.
- During workout mode, change parameter for Time/
Distance window.
Bluetooth
- Switch on the bluetooth function to pair a smart
device with the console.
- Switch off the bluetooth function when being in on
mode.
Explanation of display items (Fig. H)
Dot Matrix
- Shows the program course during workout.
- Dot matrix shows program profile in program
selecting mode.
- Shows programming parameter in programming
mode.
Speed
- Shows the actual treadmill speed in workout mode.
- Shows target speed in programming mode.
Incline/ Prog
- Shows the actual treadmill incline in workout mode.
- Shows target incline in programming mode.
- Shows program selection when being in program
mode.
Distance/ Time
- Shows the ran distance workout mode.
- Shows the target distance when being in
programming mode.
- Shows the ran time in workout mode.
- Shows the target time when being in programming
mode.
2 7
English