Medivators ENDO STRATUS EGA-501 Manual Del Usuario página 11

VIII. Setup and Operation
Initial Setup
1. Place the ENDO STRATUS® CO
working surface.
2. Before beginning, inspect the ENDO STRATUS CO
3. Connect the power cord to the back of the device.
4. Before connecting the power cord to the hospital grade wall receptacle, make sure the power is off, and no
accessories are connected. Then plug the power cord into the wall receptacle.
5. Assemble the water bottle holder and warmer assembly in the following manner:
A. The following supplies are necessary and can be found in a bag attached to the water bottle
holder:
B. Attach the water bottle holder to the base tray using the (2) small screws and small hex key.
C. Place the ENDO STRATUS CO
using the large hex key.
INTERNATIONAL_ IFU-52 (CO2 INSUFLATOR PUMP) REV H .indd 11
insufflator on a flat surface such as an accessory cart or other suitable
2
a.) Short Screws (2)
b.) Long Screws (2)
c.) Large Hex Key
d.) Small Hex Key
insufflator on the base tray and install the (2) long screws
2
insufflator for any signs of damage.
2
11
IFU-52/ REV H
12/11/2015 9:31:57 AM