Medivators ENDO STRATUS EGA-501 Manual Del Usuario página 6

IV. Product Features
• Internal CO
• Includes control for optional water bottle warmer to maintain water at close to body
temperature
• Stackable with the ENDO STRATUS® irrigation pump
• Standard male luer lock output
• Uses standard "D" or "E" size CO
• Accepts input from wall CO
• Usable at CO
supply
• Works with disposable ENDO SMARTCAP® and ENDOGATOR® hybrid tubing for safety and
compliance
Safety Features
•
•
•
•
•
Theory of Operation
The ENDO STRATUS CO
then controlling the output of CO
gastrointestinal tract. The clinician will use the air/water valve on the GI endoscope and visual feedback of the
GI endoscopic system to manually distend the gastrointestinal tract with CO
The ENDO STRATUS CO
control delivery of CO
erance of +3°C. Warming is achieved as CO
by the user, depending on if warming of the CO
an internal 20W heating element with dual redundant temperature sensors.
The flow rate can be adjusted to low, medium or high settings depending on the desired rate of insufflation,
with flow rates of 1.4 L/min, 2.4 L/min and 3.5 L/min maximum, respectively.
When the unit is turned on, the CO
must turn the flow setting knob from the "off" position. The unit will detect gas flow and will not allow the heater
to operate unless gas flow is detected. In addition, there is a low gas pressure sensor and the unit will indicate
when the input CO
2
The unit also has an output to power the water bottle warmer. The water bottle heating element maintains the
temperature of the water in a sterile water bottle at 37±3°C. It is controlled by dual temperature sensors for
redundancy and safety.
V. Technical Specifications
Electrical Specifications
Input Voltage:
Input Frequency:
Power Consumption:
Fuse Rating:
IFU-52 / REV H
INTERNATIONAL_ IFU-52 (CO2 INSUFLATOR PUMP) REV H .indd 6
warmer eliminates cold CO
2
with standard DISS type connection
2
input pressures lower than most comparable units, making efficient use of tank
2
Dual inline pressure regulators ensure a constant pressure
Additional mechanical pressure relief at ≤12 PSI prevents overpressure
Low CO input pressure is indicated by a yellow light on the front panel
2
On initial power up, gas flow is off until the flow knob is turned on
CO warmer will not operate unless flow is initiated
2
insufflator works by regulating CO
2
to an GI endoscope system for ultimate delivery as a distention media in the
2
insufflator contains a CO
2
to the patient that has been warmed to a target temperature of 37°C with an upper tol-
2
flows across a heating element which can be switched on or off
2
2
flow and heating function are off by default. To initiate gas flow the user
2
pressure reaches 25PSI by illuminating a yellow light on the front panel.
100-240 VAC
50-60 Hz
82 VA
M10AL250V
Medium acting, 10 amp, low breaking capacity, 250 volt
Replace fuses only with those of same type and rating
2
cylinders
2
from a tank source to a preset pressure and
2
2.
warming feature that allows the clinician to modulate and
2
is desired. The heating of the CO
6
is accomplished through
2
12/11/2015 9:31:55 AM