Stiga MPST 84 Li 48 V1/V2 Manual De Instrucciones página 293

• Do not carry out repairs on the
battery. Repairs must be carried
out by the manufacturer or by a
specialized service centre.
SAFETY INSTRUCTION
The noise and vibration levels shown in these
instructions are the maximum levels when using
the machine. The use of an unbalanced cutting
element, the excessive speed of movement, or
the absence of maintenance have a significant
influence on noise emissions and vibrations.
Consequently, it is necessary to take preventive
steps to eliminate possible damage due to
high levels of noise and stress from vibration;
maintain the machine well, wear ear protection
devices, and take breaks whilst working.
Storage
To reduce fire risks, do not leave
containers with debris inside a room.
3.5 ENVIRONMENTAL PROTECTION
Protecting the environment must be a
significant and top priority for machine
use, to the benefit of civil co-habitation
and of the environment that we live in.
• Scrupulously comply with local regulations
for the disposal of packaging, deteriorated
parts or any elements with a strong
environmental impact; this waste must
not be disposed of with regular waste, but
must be separated and taken to collection
centres, which will recycle the materials.
• Comply with local regulations for
the disposal of waste materials.
• When the machine is withdrawn from service,
do not dispose of it in the environment,
but take it to a waste disposal facility in
accordance with the local regulations in force.
Do not throw electrical equipment away
with domestic waste. According to the
European Directive 2012/19/EU on
electrical and electronic equipment
waste and its implementation in
compliance with national standards, old electrical
equipment must be collected separately, for eco-
compatible recycling. If electrical equipment is
disposed of in dumps or in landfills, hazardous
substances can leak into the groundwater and
contaminate the food chain, damaging your
health and well-being. For further information on
the disposal of this product, contact your dealer
or a domestic waste collection service.
At the end of their working life, dispose of
batteries with all due care and in
compliance with applicable local
legislation. Batteries contain materials
classified as hazardous for people and
the environment. They must be removed and
disposed of separately at a facility that accepts
lithium-ion batteries.
Separate waste collection of the products
and packaging used allows the materials
to be recycled and reused. Reuse of
recycled materials help to prevent
environmental pollution and reduces the
demand for raw materials.
4. ABOUT THE MACHINE
4.1 MACHINE DESCRIPTION
AND INTENDED USE
This machine is a ride-on lawn
mower with seated operator.
The machine is equipped with an
electric motor that drives the cutting
means and an electric drive motor.
The machine has rear-wheel drive.
The operator is able to operate the
machine and use the main controls, always
seated in the operator's position.
The safety devices installed on the machine will
disengage the engine and cutting means in a
couple of seconds (par. 7.2.2).
4.1.1 Intended use
This machine was designed and built to cut grass.
In particular, the models:
• MP 84 Li 48 Series V1/V2 and
MP 98 Li 48 Series V3 can:
1. mow the grass and collect it
in the grass catcher;
2. mow the grass and discharge it on to the
ground through the rear part (if available).
3. mow the grass, chop it and discharge it on
the ground (mulching effect, if available).
EN - 7