Stiga MPST 84 Li 48 V1/V2 Manual De Instrucciones página 320

PROBLEM
8. The icons in fig. 13.E and
fig. 13.O remain ON, battery
LEDs 1 and 3 flash.
Pushbutton panel
type "I" and "II"
Pushbutton panel of type
"III"
9. The icon in fig. 13.E remains
ON and battery LEDs 1, 3
and 5 flash.
Pushbutton panel
type "I" and "II"
Pushbutton panel of type
"III"
10. The icons in fig. 13.E and
fig. 13.O remain ON, battery
LEDs 1, 2 and 4 flash.
Pushbutton panel
type "I" and "II"
Pushbutton panel of type
"III"
11. The icons in fig. 13.E and
fig. 13.O remain ON, battery
LEDs 1, 2, 4 and 5 flash.
Pushbutton panel of type
"I" e "II"
Pushbutton panel of type
"III"
Cause
Cutting means motor
over-temperature
caused by:
Work conditions
too demanding.
Cutting means motor
stall caused by:
1. Work conditions
too demanding.
2. Obstructions that
prevent rotation of
the cutting means.
3. The cutting
means assembly
is full of grass
Drive motor over-
temperature caused by.
1. Drive motor
under stress.
2. Slope too steep .
3. Excessive mud
on the wheels.
The machine starts
with the drive pedal
not released (not in
neutral position).
EN - 34
Remedy
Turn off the machine, wait for at least
5 minutes and then restart it.
Reduce forward speed:
Increase the cutting height:
Reduce forward speed:
Increase the cutting height:
Remove the obstructions.
Clean the cutting means assembly:
Switch off the machine and wait for at least 5
minutes before repeating the starting procedure.
Reduce forward speed:
Reduce speed and check the slope of
the ground where you are working.
Make sure that the wheels are not
blocked and clean as needed.
Switch off the machine and repeat the starting
procedure only after having checked that the drive
pedal is in the neutral position (pedal released).