+GF+ RPC D/PID Manual De Instrucciones página 25

Operating Instructions
3) X4 - Socket M8, 4-pin (Binary outputs to the control station)
Pin Assignment
1 Binary output 1
2 Binary output 2
3 Binary output GND
4 Not connected
4.5.4 Electrical connection procedure:
1. Connect the type RPC positioner according to the tables. After applying the operating voltage, the RPC type is in operation.
2. Now make the required basic settings and adjustments for the positioner/process controller. The procedure is described in
chapter " Putting into operation type RPC D".
NOTE!
Connect the Pt 100 sensor via 3 lines to compensate for the line resistance. Pin 3 and pin 4 must be bridged at the sensor.
Type RPC D/PID positioner
3
1
4
2
25