Risks Related To Exhaust Gases And Fuels - SDMO RL6-1b Manual De Uso Y Mantenimiento

Consumables
Observe regulations in force concerning use of fuel before using your generating set, pump unit or lighting tower.
Under no circumstances use seawater or any other corrosive or electrolytic product in the cooling circuit.
Environment
The operator must take the necessary measures to comply with the aesthetics of the site of use. The whole site must be maintained
in a good state of cleanliness.
The premises must be kept clean, and be regularly cleaned so as to avoid accumulation of dangerous materials or pollutants and
dust, which could ignite or cause an explosion. The cleaning equipment must be suited to the risks posed by the products and dust.
The presence of dangerous or combustible materials inside premises housing combustion devices shall be limited to the operating
requirements.
Facilities must be operated under the constant supervision of a qualified person, who must regularly check that the safety devices
are operating correctly and ensure that the combustion devices have the correct fuel supply.
Apart from the combustion devices, it is prohibited to use fire in any form. This restriction must be clearly displayed.
Spreading of waste water, sludge and waste is prohibited.
The fuels to be used must correspond to those featured in the declaration file and the specifications recommended by the
combustion device manufacturer.
The fuel is considered to remain in the same physical state as when it is introduced into the combustion chamber.
Burning of waste in the open air is prohibited.
Always protect your hands when checking for leaks. Pressurised liquids may penetrate body tissue and cause serious damage.
Risk of blood contamination.
Drain and dispose of engine oil in a specially provided container (fuel distributors can collect your used oil).
Except by special agreement, once closed, the gas supply main unit must only be re-opened by the gas distributor. However, the
user may access it under certain conditions. Check these for each site.

1.3.2 Risks related to exhaust gases and fuels

The carbon monoxide present in exhaust gases may cause death if the concentration levels in the air
breathed are too high.
Always use generating sets, pump units or lighting towers in a well-ventilated place where gases cannot
accumulate.
In case of indoor use:
Be sure to evacuate exhaust gases outdoors.
Danger
Provide appropriate ventilation so that personnel present are not affected.
Observe the local regulations in force for generating sets, pump units or lighting towers, as well as local regulations for use of fuel
(petrol, diesel fuel and gas) before using your generating set, pump unit or lighting tower.
Fuel filling should be carried out when the engine is off (except for generating sets with an automatic filling system).
Engine exhaust gases are toxic: do not run the generating set, pump unit or lighting column in unventilated premises. If installed in
a ventilated room, additional requirements for fire and explosion protection must be observed.
A leaking burnt gas exhaust may increase the sound level of the generating set, pump unit or lighting column. To check on its
efficiency, regularly examine the burnt gas exhaust.
Pipes must be replaced as soon as their condition demands it.
46/372