Faults And Alarms - Details; Generating Set; Lighting Column - SDMO RL6-1b Manual De Uso Y Mantenimiento

7. Faults and alarms - Details

7.1. Generating set

The engine will not start
The LEDs do not come on

7.2. Lighting column

Cable incorrectly wound
The hoist does not
Incorrect crank handle direction of rotation
raise the column
Brake worn
Brake clutch penetrated with oil and/or grease
The brake does not
release, or lowering
Clutch mechanism or crank handle locked
problems
The automatic
brake stops working
(load is not Incorrect tightening with the hexagonal screw
maintained)
The generating set
differential circuit
Insulation fault when lighting column in use.
breaker is triggered
The generating set cannot distribute the current
when the lights are
required to supply the lighting column lights
switched on
One or more bulbs
do not come on
Bulbs defective or blown
Probable causes
Fuel level too low
Faulty module supply fuse
ON/OFF switch in "OFF" position
Emergency stop button pressed
Faulty battery
Faulty module supply fuse
Faulty battery
ON/OFF switch in "OFF" position
Probable causes
Probable causes
Probable causes
Probable causes
Probable causes
Fill up with fuel
Check and replace the fuse
Turn the switch to "ON"
Release the emergency stop button
and reset the fault, moving the switch
to "OFF".
Check and replace the battery if
necessary
Check and replace the fuse
Check and replace the battery if
necessary
Turn the switch to "ON"
Wind the cable correctly
Turn the crank handle the right way (clockwise)
Check the brake, and replace the worn parts
Clean or replace the clutch
Unlock it by tapping the handle anti-clockwise.
Have the brake checked or replaced
Check the electrical installation.
Check the power supplied by the generating set
Before replacing the bulb, it is advisable to perform a
test by fitting the bulb that is supposed to be blown in a
light whose bulb was working
67/372
Remedial action
Remedial action
Remedial action
Remedial action
Remedial action
Remedial action