Switching The Lights On And Off; Shutting Down The Generating Set - SDMO RL6-1b Manual De Uso Y Mantenimiento

6.3. Switching the lights on and off

After closing the main circuit breaker, the lights can be switched on and off using the 4
circuit breakers located on the front panel (figure 6.3).
Lamp circuit
breakers
The lights require a preheating period (10 to 15 minutes) in order to reach their maximum brightness.

6.4. Shutting down the generating set

Switch off the lights by opening the associated circuit breakers.
Open the main circuit breaker.
Let the engine run under no load for 1 to 2 minutes to allow it to cool.
Turn the key switch to the OFF position (the MODYS module is switched off), the generating set will stop.
Note: It is not possible to restart the generating set until it has fully stopped.
Figure 6.3 – Light control circuit breakers
65/372