Maintenance; Pre-Start Inspection - SDMO RL6-1b Manual De Uso Y Mantenimiento

9. Maintenance

9.1. Pre-Start Inspection

Inspection round
Note loosened bolts, deposits of waste, and oil, fuel or refrigerant leaks, and damaged or worn components.
Check the cleanliness of the column components and its general condition, in order to detect any fault that might
compromise safety.
Checking the engine oil level
The engine must be in the horizontal position for the oil level check. Pull out the dipstick, clean it, put it back in the
tube for 2 seconds and pull it out again so that you can read the oil level.
Warning
The engine oil level must be between the MAX and MIN marks on the dipstick.
Top up the oil if necessary
70/372